Splitboarding is quite a simple concept where a snowboard that divides lengthwise in two is used as two approach skis for you to access the backcountry. However, once you are on top of your destination already, a simple hardware is provided so as to put back together your ski to make a snowboard that you use to ride back down the mountain. It is said to be more efficient once you use skis with skins on the bottom of your split board rather than having snow shows or merely hiking alone. It makes splitboarding the most efficient way in order to access the backcountry on foot when the long surface area is combined with the stability of the skis under the feet.

 

Much similar to cross country skiing, splitboarding enables as well for free heel movement particularly if the skins are attached to the bottom of the skis to give uphill traction. Read further details about this in the site at http://en.wikipedia.org/wiki/Splitboard. It is sometimes referred to as backcountry or ski touring because you do use your own power so as to access the backcountry, which are usually located on unmaintained trails. It can take you a couple of hours or even a few weeks for the expedition.

 

Before you can ultimately enjoy splitboarding, it is one crucial decision to pick the correct split board. It is quite expensive but they have a number of different sizes, shapes and intended use that you can select from. Regarding the sizing, this will greatly rely on the purpose of your split board. You should decide whether you will use it throughout the season or just for a short time. You also need to choose if you want backcountry kicking or long distance travel deep into the wild. You also need to think of having your board when you do overnight trips. There are several factors to remember before making your purchase.

 

The general rule of thumb when choosing a split board is to have it longer by about five centimeters than your freestyle board. So, if you ride a free-ride board, there is no need to choose one that is much bigger at all. Once your board is intended merely for power riding, select one that is a slightly longer or have specialty splitboards instead. For overnight trips where you ought to carry a heavy load, you must add some length to be used for flotation. When your custom splitboard will be used right through the season, adding length needs to be done more conservatively.

 

An additional significant consideration is the waist width of your split board. Select a waist width at www.prowder.com that will work properly with the size of your boot. A narrow board will take toe and heel drag that can deter your turn. It can also be downright dangerous when you boot out on a steep and firm slope. Once it is too wide, it will be tough to go from one edge to another and your turns will feel sluggish.